There are a couple miscellaneous curved pieces of the frame left to make. The first one I mentioned in my last post, the ring segment that goes under the large dataport. Unlike the other ring segments this one is only 1/4” thick. The best material for this was 1/4” MDF. I made this piece the same way as the other ring segments.
The final two curved pieces are he shoulder wings. I cut the outside edge on the router table using the same jig from the ring segments, and I did the notches on the table saw jig. The straight edge on the back was rough cut on a band saw and then I sanded it down to the line on a belt sander. The notches were carefully cut on the band saw.
No comments:
Post a Comment